Questions ?
Call us at 905-624-5536		 HH Roberts Machinery logo
male H.H. Roberts Machinery Limited
1324 Matheson Blvd E., Mississauga, Ontario, Canada. L4W-2Z7, Fax 905-624-9065 		credit card logos
Shanghai Z-5030-A    1.18" drill press
This model is normally in stock
Shanghai Z-5030-A Geared Head Drill with Power Feeds and Semi-automatic Tapping Cycle
  Drilling capacity 1.18" 30 mm
Tapping capacity 3/4" NC M20
Diameter of column 4.74" 120 mm
Spindle travel 5.34" 135 mm
Distance spindle axis to column 12.65" 320 mm
Max.Distance spindle nose to table 21.65" 550 mm
Max.Distance spindle nose to base 43.3" 1110 mm
Spindle taper MT3
Spindle speed range 78 ～ 3,120 RPM
Note: speeds previously posted were for 50 cycle electrics.  The above speeds are correct for 60 cycle power supply
Number of spindle speeds 12
Spindle feeds 3
Feed rates 4, 8 and 12 thou / rev 0.1, 0.2, 0.3 mm / rev
Dimension of worktable surface 19.68" x 17.71" 500 × 450 mm
Max. travel of worktable 21.65" 550 mm
Dimension of base 16" x 15.6" 405 × 395 mm
Worktable and base T-slots 2-14mm and 2-18mm
Power of Main motor - 2 speed 1.3 / 2 Hp 1.0/1.5 Kw
Coolant motor ( optional ) 1.6 US GPM 6 L/Min
  Net Weight 968 Lb. 440 Kg.
Packing dimennsions 37" x 22.44" x 88.6" 94 × 57 × 225 cm
Shanghai Z5030A geared head drill with 1.18" capacity and power feeds

Standard Equipment and features

• Geared headstock with hardened and ground steel gears

• Three power feeds actuated by pushbuttons in each feed lever, engaged by electromagnetic clutch,
      with release built into the depth gauge.

• Semi-automatic tapping cycle. Spindle runs forward to tap and reverses when the pushbutton in the
      feed lever is pushed, then reverses again at the top of the stroke, ready for the next hole.

• Gear driven system, 12 speed steps

• Worktable can be rotated ±180°and tilted　±45°

• Coolant system.

• Adjustable depth stop with inch and metric scales

• Table height is adjustable on the column through a geared lift

• Both head and table have double acting linked clamps

• Drill speed chart for iron and steel on faceplate

• Drill chuck guard with built in switch to CE standards

• Available with 600/3/60 electrics, CSA approved, and 230/3/60

• Standard equipment includes a MT3-2 and MT3-1 sleeve, drift, anchor bolts and manual.

• Worklight is optional