Loading
Questions ?
Call us at 905-624-5536
Call us at 905-624-5536
1324 Matheson Blvd E., Mississauga, Ontario, Canada. L4W-2Z7, Fax 905-624-9065
 |
 |
| Search our site Loading
|
|
Questions ? Call us at 905-624-5536 |
||||
| H.H. Roberts Machinery Limited 1324 Matheson Blvd E., Mississauga, Ontario, Canada. L4W-2Z7, Fax 905-624-9065
|
||||||
 System IITM Adaptive Drawbar Dynamometer Download the brochure (pdf) |
||
|
|
 drawbar force gauge (dynamometer) |
Precision Maintenance Tool Provides accurate drawbar force measurements on steep taper (CAT, BT, DIN, etc.) and HSK machining centers. Verifies the machine's drawbar performance against the manufacturers' specifications or from readings taken when the machine was new to ensure optimum cutting tool performance. Fast Performance Quickly identifies if retention force losses are at fault when poor surface finishes appear or when tool performance deteriorates. Services Entire Machine Shop A compact load cell with an electronic display and a family of taper adaptors combine to make a single measuring unit that can service an entire machine shop employing a variety of machining centers. Simple Operation Operation is fast and easy. Simply attach the taper adaptor and retention knob adaptor, screw in a retention knob, and install it in your spindle like an ordinary toolholder. The load cell is stretched by the machine's drawbar. This stretch is measured electronically and is instantly displayed on the digital readout. Spring deterioration or maladjustment can be detected in no time. No costly disassembly. No machine downtime. Convenient Display Features standard 0-10,000 lb. range, large easy-to-read digital display, auto-off feature and touch sensitive buttons sealed for dust-proof operation. 1000 Hours Operation Operates on two 9 volt batteries for up to 1000 hours continuous operation. Calibration data is stored on a non-volatile memory. Custom Calibration Available Standard calibration is 0-10,000 pounds. Can be custom calibrated. Call for quote. Re-Calibration and factory re-certification service is available. Turn around is typically only 48 hours. There is no bench charge if the unit is not repairable. |
||
| Components of a Command Dynamometer see part numbers below this table One part from each row is needed to assemble a test rig |
||
| 1 |  |
The pull studs can be any style to match your machine. You can use pull studs that you already have. |
| 2 |  |
The Pull Stud Adaptors are interchangeable on each size sleeve The thread must match you pull stud. |
| 3 |  |
Taper adaptors sleeves: Cat-V BT HSK custom adaptors also available Note for HSK you must match the syle type A, E, or F. |
| 4 |  |
Dynamometer body |
| The dynamometer is supplied in a foam filled carrying case. If you have a large number of different pull studs in your shop, there is a pull stud adaptor pallet that will fit into the case. |
|
|
||||||||||||||||||||||||||||||||||||||||||||
|
|
||||||||||||||||||||